New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !

Emule for bubba2

Got problems with your B2 or B3? Share and get helped!
Post Reply
Strider
Posts: 20
Joined: 14 Jun 2007, 20:29

Emule for bubba2

Post by Strider »

Hi,

I have searched the forum and for Bubba server some good folks have installed mldonkey.
Does anybody uses a command line emule like client?

What do you use and how did you install it on bubba 2.

Thanks in advance,

Regards,

Note: I just received my Bubba 2 server! It ROCKS ! :)
Top
Strider
Posts: 20
Joined: 14 Jun 2007, 20:29

Post by Strider »

Hi,

I was yesterday concerned with the WD disk issue and therefore I did not continued this thread.
I installed mldonkey following this link:

http://forum.excito.net/viewtopic.php?t=88

And the mldonkey official wiki.

I downloaded from sourceforge the lattest code, version 2.9.7, and compiled it after installing the dependencies mentioned on the above link, and also on the mldonkey wiki.
I made some changes that I do not remember now, but the thing works!

I created a user and th program runs on that user account.
Everything is runing ok and I use the normal web interface provided by MLDonkey.
Just start the mlnet from the user account, restart the processes (stop/kill and start again) to make sure the setup files are written correctly and them connect from the browser:
http://bubba:4080

That's it!


Regards
Top
paolol61
Posts: 99
Joined: 20 Nov 2007, 04:18

Post by paolol61 »

the only problem i have not yet fixed is to have the process restart by himself when bubba need to be restarted :(
8)
Top
Post Reply

Return to “B2 & B3 Support”