2 Hz blinking during install

Got problems with your B2 or B3? Share and get helped!
Post Reply
squeaky
Posts: 1
Joined: 15 Sep 2010, 12:32

2 Hz blinking during install

Post by squeaky » 15 Sep 2010, 12:54

Hello, I recently bought a bubba and replaced the harddrive today.

inserted an old external ide drive into my mac and formated it to contain a single fat32 partition where i put the /install folder.

started the bubba with the external ide in one of the usb ports and held the reset button for quite a few seconds.

But nothing seems to happen, the led is blinking at 2 Hz, not 4 as the manual stated that it should, both harddrives are spinning but they are not making the 'click' sounds that harddrives usually do when reaing/writing.

Does anyone know what the 2 Hz blinking during install means? Is the problem with the external or the internal disk?

Post Reply