2 Hz blinking during install
Posted: 15 Sep 2010, 12:54
Hello, I recently bought a bubba and replaced the harddrive today.
inserted an old external ide drive into my mac and formated it to contain a single fat32 partition where i put the /install folder.
started the bubba with the external ide in one of the usb ports and held the reset button for quite a few seconds.
But nothing seems to happen, the led is blinking at 2 Hz, not 4 as the manual stated that it should, both harddrives are spinning but they are not making the 'click' sounds that harddrives usually do when reaing/writing.
Does anyone know what the 2 Hz blinking during install means? Is the problem with the external or the internal disk?
inserted an old external ide drive into my mac and formated it to contain a single fat32 partition where i put the /install folder.
started the bubba with the external ide in one of the usb ports and held the reset button for quite a few seconds.
But nothing seems to happen, the led is blinking at 2 Hz, not 4 as the manual stated that it should, both harddrives are spinning but they are not making the 'click' sounds that harddrives usually do when reaing/writing.
Does anyone know what the 2 Hz blinking during install means? Is the problem with the external or the internal disk?