Bridge WAN and LAN interfaces on B3 - SOLVED
Posted: 19 Oct 2013, 03:42
Dear all
I've been trying to bridge the LAN and WAN interfaces on my B3 in order to be able to connect an additional device to my LAN (see attachment for details).
Now I've modified /etc/network/interfaces as follows, but I can't access the B3 anymore after reboot:
Using the usb recovery, I've modified it to use DHCP. But the B3 does not even pull an IP on either interface after reboot:
What am I overlooking here?
I've been trying to bridge the LAN and WAN interfaces on my B3 in order to be able to connect an additional device to my LAN (see attachment for details).
Now I've modified /etc/network/interfaces as follows, but I can't access the B3 anymore after reboot:
Code: Select all
# The loopback network interface
auto lo br0
iface lo inet loopback
# Set up interfaces manually, avoiding conflicts with, e.g., network manager
iface eth0 inet manual
iface eth1 inet manual
# Bridge setup
iface br0 inet static
bridge_ports eth0 eth1
address 192.168.0.6
netmask 255.255.255.0
gateway 192.168.0.1
Code: Select all
# The loopback network interface
auto lo br0
iface lo inet loopback
# Set up interfaces manually, avoiding conflicts with, e.g., network manager
iface eth0 inet manual
iface eth1 inet manual
# Bridge setup
iface br0 inet dhcp
bridge_ports eth0 eth1