Hi,
Just got may Bubba yesterday and am now transferring my files over via ftp. I have connected it to a 100Mbit switch but can't seem to get transfer rates over 3Mbyte/s. I have had rates ~ 9Mbyte/s from my computer. I have no other transfers going to either computer.
Thanks
New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !
FTP transfer rate
I think I've found the weak link. I tested the read speed of the HD and this is what I found:
/dev/hda:
Timing cached reads: 244 MB in 2.02 seconds = 120.83 MB/sec
Timing buffered disk reads: 24 MB in 3.14 seconds = 7.65 MB/sec
Can this be right? I get about 10 times the speed on my main computer. These are my hdparm settings for /dev/hda
/dev/hda:
multcount = 0 (off)
IO_support = 0 (default 16-bit)
unmaskirq = 0 (off)
using_dma = 0 (off)
keepsettings = 0 (off)
readonly = 0 (off)
readahead = 256 (on)
geometry = 60801/255/63, sectors = 976773168, start = 0
Which of these would be safe to change?
/dev/hda:
Timing cached reads: 244 MB in 2.02 seconds = 120.83 MB/sec
Timing buffered disk reads: 24 MB in 3.14 seconds = 7.65 MB/sec
Can this be right? I get about 10 times the speed on my main computer. These are my hdparm settings for /dev/hda
/dev/hda:
multcount = 0 (off)
IO_support = 0 (default 16-bit)
unmaskirq = 0 (off)
using_dma = 0 (off)
keepsettings = 0 (off)
readonly = 0 (off)
readahead = 256 (on)
geometry = 60801/255/63, sectors = 976773168, start = 0
Which of these would be safe to change?