Hello, I recently bought a bubba and replaced the harddrive today.
inserted an old external ide drive into my mac and formated it to contain a single fat32 partition where i put the /install folder.
started the bubba with the external ide in one of the usb ports and held the reset button for quite a few seconds.
But nothing seems to happen, the led is blinking at 2 Hz, not 4 as the manual stated that it should, both harddrives are spinning but they are not making the 'click' sounds that harddrives usually do when reaing/writing.
Does anyone know what the 2 Hz blinking during install means? Is the problem with the external or the internal disk?
New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !