Hi
I have bought a USB stik to re install my Bubba2,
but I have completely lost connection to the server.
The re install process works fine in the start- the blue LED flashes with 4 kHz and the
USB device begins to install (it lights up and flashes).
It goes on for 4-5 min. then the LED light begins flashing with 1 kHz
- and I can not get in contact with the server.
I have tried several times, trying to put the server directly into my
Telia modem or my wireless routes, but it gives the same result
Some good experience / advice for a very frustrated man?
Regards
Martin
New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !
Re-install problem Bubba2
Re: Re-install problem Bubba2
Hi,
It is quite sensitive to how the file systems/partitions on your usb-stick are configured. I had to try several physical usb-devices before it worked, even though the partition table looked the same on all of them. I just found one that worked in the end. I know it doesn't make sense, but it seems there is some fairy magic involved in the bubba boot-sticks.
Sent from my HTC Desire using Tapatalk
It is quite sensitive to how the file systems/partitions on your usb-stick are configured. I had to try several physical usb-devices before it worked, even though the partition table looked the same on all of them. I just found one that worked in the end. I know it doesn't make sense, but it seems there is some fairy magic involved in the bubba boot-sticks.
Sent from my HTC Desire using Tapatalk
Re: Re-install problem Bubba2
I couldn't get anything to work, not usb sticks, nor usb hard drives. Eventually got a usb hard drive to work (formatted it on windows 7 using acronis disk director), created two partitions on it, just to ensure that I was actually creating a partition table. Don't know if that made any different or not.