Hi jamerson,
Good to see you're back.
Here is the original web-admin: web-admin-original.zip (~138 KB)
Keep us posted.
New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !
Tiny little hack... 0.50.1
Hi Jamersson,
Ftd do some minor logging to /var/log/daemon but you should get better information if you run ftd in the foreground.
Log in to bubba as root.
Stop ftd
Start ftd in foreground mode
Then you should get better information on what is going on.
If that gives nothing. Running the daemon in a debugger would be the next step.
/Tor
Ftd do some minor logging to /var/log/daemon but you should get better information if you run ftd in the foreground.
Log in to bubba as root.
Stop ftd
Code: Select all
/etc/init.d/ftd stop
Code: Select all
ftd -f
If that gives nothing. Running the daemon in a debugger would be the next step.
/Tor
Co-founder OpenProducts and Ex Excito Developer
Admin panel to assign static IP does not allow data entry
I wanted to try the new web-admin out so I moved /usr/share/web-admin to /usr/share/web-admin.sav as root, then unzipped the new web-admin into /usr/share and restarted apache2.
While the download manager works just fine, when I tried to change from using a dynamic IP address assigned by DHCP to using a static address I could not fill out the needed fields (such as ip address, default gateway, netmask, etc.)
When the dynamic IP radio button us selected, all the fields are grayed out and cannot be filled out. Selecting the Assign manual ip address radio button leaves the fields unchanged.
After going back to the default web-admin interface and trying to assign a static IP address, the fields can be filled out.
I am not a PHP coder, so I was not able to troubleshoot this further.
Thanks in advance for any help.
Tom Porter
While the download manager works just fine, when I tried to change from using a dynamic IP address assigned by DHCP to using a static address I could not fill out the needed fields (such as ip address, default gateway, netmask, etc.)
When the dynamic IP radio button us selected, all the fields are grayed out and cannot be filled out. Selecting the Assign manual ip address radio button leaves the fields unchanged.
After going back to the default web-admin interface and trying to assign a static IP address, the fields can be filled out.
I am not a PHP coder, so I was not able to troubleshoot this further.
Thanks in advance for any help.
Tom Porter