I install an 120GB Sandisk SSD in the B3 and run the install process with the usbstick. "Hold the powerbutton an plug in the cable."
-First time the front led is green and the stick led in on.
-After 1 minute the usbstick blink for 15 seconds
and than is still on. The front led is green.
-After 3 minutes the stick-led blink one times
the led on the lan and wan port is on the front led is red.
-every 23 seconds, the last process repeats
"the stick-led blink one times the led on the lan and wan port is on the front led is red"
Before i tried to install the SSD i confirm that
the installation works with an normal 3,5" HDD.
What can i make to run it?
Thanks for all Ideas
New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !
SSD doesn´t work work
Re: SSD doesn´t work work
just for completeness: did you use the same USB stick when you successfully installed on the 3.5" disk?
Re: SSD doesn´t work work
yes of course. After 3 times i format the SSD and USB stick and copied all files again. The Same result.
Re: SSD doesn´t work work
Then you will also have tried te SSD in another computer to make sure it's OK? And you have also partitioned the SSD for use in a B3?
Re: SSD doesn´t work work
yes of course. that was the First check.
Re: SSD doesn´t work work
first time with win7 exfat
second time osx exfat
third time with a b3 disk format raw
this was a looong night
second time osx exfat
third time with a b3 disk format raw
this was a looong night