SSD doesn´t work work

[mohamed]

I install an 120GB Sandisk SSD in the B3 and run the install process with the usbstick. "Hold the powerbutton an plug in the cable."

-First time the front led is green and the stick led in on.

-After 1 minute the usbstick blink for 15 seconds
and than is still on. The front led is green.

-After 3 minutes the stick-led blink one times
the led on the lan and wan port is on the front led is red.

-every 23 seconds, the last process repeats
"the stick-led blink one times the led on the lan and wan port is on the front led is red"

Before i tried to install the SSD i confirm that
the installation works with an normal 3,5" HDD.

What can i make to run it?

Thanks for all Ideas

[Ubi]

just for completeness: did you use the same USB stick when you successfully installed on the 3.5" disk?

[mohamed]

yes of course. After 3 times i format the SSD and USB stick and copied all files again. The Same result.

[Binkem]

Then you will also have tried te SSD in another computer to make sure it's OK? And you have also partitioned the SSD for use in a B3?

[mohamed]

yes of course. that was the First check.

[mohamed]

first time with win7 exfat
second time osx exfat
third time with a b3 disk format raw
this was a looong night